1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 291Get this manual
Propeller Shaft Bearing Housing Service 432127, and OMC Small Puller Jaws, PIN 432131Position the plate on top of the housing to support the bridge, and tighten the jaws securely behind the sealINotellnspect bearings in placeIf bearing is removed for any reason, it must be discarded2Remove either bearing using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Rest the puller plate on top of the housing to support the bridge, and tighten the jaws securely behind the bearing3Discard the bearing housing a-ringsClean the housing and bearings in solvent, and dry thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movementInspect a-ring grooves; sand off any sharp edges that would cut a-ring and prevent its sealing W 1Remove the seal using OMC Puller Bridge, PIN