1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 290Get this manual
4513 4514 4515
19Pull up on the detent lever until it snaps into the NEUTRAL positionPush the pivot pin out of the housing, then reach inside and pull the shifter CD off the detent leverball and spring can come out with great force while removing the detent
& Wear safety glasses to prevent personal injuryThe detent
20Wrap the housing with shop clothRotate the detent lever 90 in either direction, then pull the detent lever out of the housing
120 21Remove the detent ball Q) and spring Remove the 25
forward gear needle bearings22The forward gear bearing and bearing housing are serviced as an assemblyIf either is worn or damaged, replace the entire assembly
23Remove the pinion bearing only if it needs to be replacedBefore attempting removal,take out the bearing retaining ring on top side of the pinion bearing, using long-handle needle-nose pliers such as Snap-On No911 CP or equivalentIf the pinion bearing must be replaced, use OMC Bearing Remover and Installer, PIN 391257, and assemble it as follows: