1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 282Get this manual
[] 5Install the water tube grommet with the inside taper facing up [[] 6Install the impeller housing cover [[] 7Apply OMC Adhesive sealant to flat side of the impeller
housing grommet
CDInstall the
grommet, flat side down
[]] 8Lightly coat the liner with oilWith counterclockwise rotation, install the impeller into the liner with slot for impeller cam facing out
[]] 9Run thin bead of 'OMC Adhesive sealant in the seal groove, and install the special shaped a-ring seal Q) Installation
1Apply OMC Gasket Sealing Compound to both sides of new impeller plate gasket Install the gasket and impeller plate 2Apply OMC Triple-Guard grease to new impeller a-ring Slide the a-ring down the driveshaft until it contacts the impeller plate
[] 3Apply OMC Needle Bearing Assembly Grease to flat area of the driveshaftInstall the drive camThe sharp edge of the cam is the leading edge during driveshaft rotation CD4Slide the water pump assembly down the driveshaftAlign slot in the impeller with the impeller camRotate the driveshaft to engage the impeller cam with the impeller, and slide water pump assembly down over impellerBe sure impeller cam does not fall out of position