1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 202Get this manual
Powerhead Servicing
This section contains certain service procedures unique to power steering equipped enginesIf your engine does not have power steering, skip those steps and go to the next procedure in sequenceRemoval
i spark leads before beginning service
'" To avoid accidental starting of engine, twist and remove all
Because of the number and types of fasteners (screws and nuts) it might be appropriate to reinstall fasteners in their holes as engine components are removedThis will simplify identification and assembly
rv screw, flat washer, supporting power steering hosesRemove 1Remove bracket and locknut2Be sure that spring clip is installed on the port and starboard lower pan supportsRemove the overboard indicator hose and grommetf21 3Loosen the lower engine cover retaining screwsRemove one spring clip and one lower cover half at timef31 4Loosen nut and lock washer and release tension on power steering belt idler pulley5Loosen and remove six screws, pulley to flywheel1s1 6Using Snap-on tool 144 or equivalent and 1716 insocket, remove flywheel retaining nutf6l7Assemble pieces of OMC Universal Puller Set, PIN 378103, and remove flywheelSee Flywheel Servicing Information Section 3f71 8Remove four retaining screws, statorcharge coil assembly to cylinder blockE u