1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 169Get this manual
Sensor Coil Ohmmeter Test
INote All
running
ohmmeter tests must be performed with engine not
18efore proceeding, you must verify that the ohmmeter red lead is the "+" leadCalibrate meter on appropriate scaleAttach to known good diode as shown Meter must show low reading When meter leads are reversed, meter must show high reading2If your test results are opposite, reverse internal meter lead connections so the red lead represents "+"
I1ID 3Attach ohmmeter red lead to port timer base connector,
terminal "0"
I1ID 4Alternately, attach ohmmeter black lead to port connector,
Stevens AT-101 meter: 360 30 ohms Merc-O-Tronic M-700 meter: 970 100 ohms Fluke 29 Series II meter: 975 100 ohms
terminals "A", "8", and "C", and starboard connector, terminals "A", "8", and "C"Meter reading at each connection should be:
INote The Fluke 29 Series II meter must be set to the low ohms