1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 110Get this manual
Installation1Install new intake manifold gaskets dryUse no sealer2V6, Upper intake manifold must be installed firstEngage throttle cam, washer, and nut on manifold stud as you install manifoldRecirculating fitting on upper intake manifold must be covered with OMC Protective Cap, PIN 322892, to prevent an air leakf81 3Apply Permatex No.2 to threads of all intake manifold eJ screws that protrude into the crankcase cavityTorque the manifold retaining screws to 60-84 inIbs(7-9 Nm) and torque the throttle cam nut to 144-168 in Ibs(16-19 Nm)4Install new carburetor base gaskets, dryInstall the carburetorRefer to Carburetor Installation, this section5To accurately adjust all carburetor linkage, refer to Synchronization and Linkage Adjustments, Section 1 va -