1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 106Get this manual

1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 106

11Install new O-ring seal, and attach main body to throttle bodyTorque mounting screws in "X" pattern to 45-55 inIbs(5-6 Nm)seal out of positionInstallation 1Install new carburetor base gaskets dry; use no sealer2Carefully, install fuel hosesRefer to Hose Routing Chart, this sectionSecure all hoses with tie straps
INote When positioning main body, be careful not to roll O-ring

1251 3link{s)
Position carburetor and engage throttle shaft connector

12s1 4Install two nuts and two screws per carburetor, and tighten in an "X" pattern to 120-144 inIbs(14-16 Nm)1271 5Route and connect all primer hosesRefer to Hose Routing

Back to 1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128