1996 Johnson Evinrude "ED" 90 LV 125C, 130, 200, 225, 250 Service Manual, P/N 507128, Page 64Get this manual
Preliminary Adjustments
1Turn the ignition stop switch knob fully counterclockwisef51 2Turn the throttle arm stop screw and the wide open t=.J throttle stop screw until the plastic caps are closest to the throttle armf51 3Loosen the throttle cable lock nut and use the throttle t=.J cable thumb wheel to center cable travelThrottle cable will travel past normal maximum settings in both directions when thumb wheel is properly adjusted4Tighten locknut f51 5There should be approximately seven threads exposed on the timer base link
t=.J spark lever slide Adjust spark lever slide screw CD as
necessaryCam Pickup Point
Isl 6'he rear edge of the spark lever should be flush with the
1sl 1Before proceeding, ensure that the throttle cam follower screw Q) is still loose1sl 2While holding the cam follower against throttle cambegin to adjust the throttle arm stop screw until the cam on the and the cam follower are touching at bisect point throttle cam