1996 Johnson Evinrude "ED" 90 CV 88 thru 115 Service Manual, P/N 507126, Page 212Get this manual
101 13To assemble inner and outer seals to bearing housing, install outer seal retaining ring into its groove in the bearing housing
1nl 14Apply OMC Gasket Sealing Compound to metal casing of each seal before installingApply OMC Triple-Guard grease to seal lips before installing inner sealInstall outer seal into bearing housing with lip facing outwardPress seal in until it makes contact with retaining ring
1101 r,v 15Install inner seal with lip facing outwardTap seal into
bearing housing using socket slightly smaller than the outside diameter of the sealWhen the seal is seated, install the inner retaining ring'12l 16Remove the seal carrier assembly and thrust washer from the driveshaft