1996 Johnson Evinrude "ED" 90 CV 88 thru 115 Service Manual, P/N 507126, Page 196Get this manual
12s1 25V4 -
Remove the water intake screen by depressing the tabs and pushing upwardInspect the screen for blockagePropeller Shaft Bearing Housing Service
1Remove the seal using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131Position the plate on top the housing to support the bridge, and tighten the jaws securely behind the seal
1 Inspect bearings in placeIf bearing is removed for any Note
reasonit must be discarded
rn 432127, and OMC Large Puller using PIN 432129Rest the 2Remove either bearing OMC Puller Bridge, PIN Jaws,
puller plate on top of the housing to support the bridge, and tighten the jaws securely behind the bearing3Discard the bearing housing a-ringClean the housing and bearings in solvent, and dry thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movementInspect a-ring groove, and sand off any sharp edges that would cut the a-ring and prevent its sealingV4Thoroughly clean the threads of the four bearing housing retaining screwsDiscard the retaining screws' seals4Inspect the bearing housing anodeReplace anode if it has eroded to two-thirds its original size