1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 243Get this manual
1.J8l 15Use OMC Bearing Puller PI 432130 attached to OMC Slide Hammer PIN 432128 to remove the forward bearing cupSecure the puller jaws into grooves behind the cup with jaws facing port and starboard Use OMC Wrench PI 334359 to hold the puller while tightening the jaws16Use OMC Puller Bridge PI 432127 and OMC Small Puller PIN 432131 to remove the driveshaft seals from the gearcase IN=J Inspect bearings in placeIf bearing
reason, it must be replaced
is removed for any
1201 17Remove the upper driveshaft bearing and bearing sleeve from the gearcase using the same two toolsDiscard the bearingf21l 18To remove the pinion bearings, assemble the following components from OMC Universal Pinion Bearing Remover and Installer PIN 391257: PI 326582 Rod PI 326583 Pilot Plate PI 326577 Remover and Installer -20 112 inHex Head Screw -20 inHex Head Screw CD in 0.0Flat Washer