1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 241Get this manual
Disassembly]1Remove the six impeller housing screws and washers2Pull up on the driveshaft and remove the driveshaft with the water pump assembly from the gearcaseDisassemble the water pump assembly from the driveshaft[] 3Remove the impeller plate and gasketDiscard the gasket[] 4Remove the two propeller shaft bearing housing screws[] 5Assemble the following components from OMC Universal Puller, PI 378103Remove the propeller shaft bearing housing from the gearcase PIN 307636 Body
Screws, -20 in(obtain locally)
307639 Flat Washers Q) PIN 307638 Handle
307637 Pressing Screw
6Remove the retaining ring using OMC Retaining Ring Pliers, PIN 331045The retaining ring is under extreme pressure during removal and installation Wear safety glasses and proceed with care to avoid unsnapping the ring from the pliersAfter the retaining ring is removed far enough from the gearcase to clear the housing, release the pliers while retaining ring is still around the propeller shaft7Remove the retainer plate from gearcase