1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 231Get this manual
16Remove the shift rod bushing as follows: Position OMC Shift Rod Bushing Remover, PIN 327693, under the shift rod bushing Thread the adapter of the Universal Slide Hammer, PIN 391008, in the slide hammerPlace the adapter through the shift rod bushing and thread into the remover tool Remove the handle from the remover toolThen remove the bushing from the gearcase Once the bushing has been removed from the gearcase, examine the bushing for damageIf damaged, replace the bushing on reassemblyRemove and discard the a-ring from the bushing1141 17Using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131, remove the two driveshaft sealsDiscard the sealsInspect bearings for damage while in placeIf bearing is damaged, remove and discardIfthe bearing is removed for any reason, it must be replacedf151 18Using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131, remove the bearing and sleeve from the gearcaseDiscard the bearingr:p;1 19Using OMCSlide Hammer, PIN 432128, and OMC Bearing Puller, PIN 432130, remove the forward bearing cup from the gearcase 16