1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 199Get this manual
Installation 1Insert the stop button wires and throttle cable through the lower motor cover grommetUse isopropyl alcohol on the sleeve to ease assembly1cl 2Apply OMC Triple-Guard grease to the steering handle sleeve and place the sleeve into the steering bracketReplace sleeve if necessary3Attach the steering handle to the bracketTighten the nut just tight enough so the steering handle will maintain any position -
i action
the steering handle locknut if it has lost its locking
4Secure the stop button ground lead behind the ignition coil on the lower screw, with star washer next to blockf71 5Use OMC Pin Insert Tool, PIN 322697, to install the stop button black wire into the 5-pin Amphenol plugf8l 6Connect the Amphenol connectorSecure the connector to the ignition coil post with tie strap