1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 150Get this manual
1 DR2661
Assembly
fN=J Proceed slowlyMake no forced assemblies unless pressr:;l r:;] 1Using components from OMC Wrist Pin Retaining Ring LJ Installer and Pressing Pin, PIN 392511, seat new retaining ring in groove of the piston When installed, gap of the ring should be positioned opposite groove in the piston
ing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
131 2Using the piston cradle and wrist pin driver, oil and start the
wrist pin into the piston wrist pin boss opposite where the retaining ring is installedDo not allow the wrist pin to enter the piston cavityPosition the top end of the connecting rod over the wrist pinApply OMC Needle Bearing Assembly Grease to the 22 needle bearings and install the bearings into the connecting rod