1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 48Get this manual
Synchronization and Linkage Adjustments -
INote It is important that this step-by-step procedure be followed INote If equipped, remove both
in sequence and be performed exactly as written to ensure consistent engine idling and smooth operation throughout the RPM rangeremote control cables from the engine before performing these adjustments
Cam Follower Pickup Point
1Tiller modelsturn the idle adjusting knob counterclockwise to full SLOW position
2Remote modelsback out throttle arm stop screw until throttle arm touches screw's mounting bracket
rncarburetor throttle shaftamplifierlike the one shown, to 3Connect throttle shaft the rn 4Advanceamplifier begins moving theAtthrottle control lever the throttle by until tip of the to movethis point, the cam
follower should contact the cam between the two marks]5To adjust, loosen the screw retaining the adjustment lever to the throttle shaftSlide the adjustment lever up or down to make the adjustmentThrottle Control Rod
[[] INote Offset on pivot block must face toward the control