1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 215Get this manual
Driveshaft Bearing Housing Service The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged IT]
1Remove the driveshaft bearing housing seal using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Discard the seal
2Remove the a-ring from the bearing housing and discard3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove14155
4Install new seal in the bearing housing using OMC Seal Installer, PIN 341439Apply oil to the casing of the seal before installingInstall the the seal with the exposed lip facing away from the bearing housingPress the seal into the housing until the tool seatsApply OMC Triple-Guard grease to the seal lips after installing5Lightly apply OMC Triple-Guard grease to new a-ringInstall the a-ring in top groove of the bearing housinghousing's bottom grooveThe bottom groove is an oil passageGearcase damage cou Id resu It