1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 203Get this manual
1241 29Position the washers on the driveshaft bearing housing screwsApply ONIC Gasket Sealing Compound to the threads of the screwsInstall and tighten screws to torque of 168-192 inIbs(19-22 Nm)1251 30V6Apply ONIC Needle Bearing Assembly Grease to the small thrust washer Place the small thrust washer in recess of reverse gear
1261 31Oil, then install the thrust bearing and thrust washer on the hub of the reverse gearSlide the reverse gear onto the propeller shaft until it engages the pinion32 Carefully apply ONIC Gasket Sealing Compound to the a-ring flange and aft support flange of the bearing housingDo not allow sealer to contact either forward thrust surface or bearings in the housingInstall the housing in the gearcase with screw holes in vertical position and anode facing downPress the bearing housing into the gearcase and tap the housing with soft face mallet to seat the a-ring