1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 201Get this manual
10 833096
COB7581
INotel The clutch dog is not symmetricalIf installed backward, it
will not fully engage reverse gear and will immediately damage itself and the gear
13V4Install the clutch dog on the propeller shaft: face the splineless lugs aft, and align its hole with the slot in the propeller shaft
14V6Align holes in the clutch dog with slot in the propeller shaftInstall the clutch dog on the shaft with "PROP END" facing rear of the shaft
15Slide the propeller shaft onto the shifter shaft, align the hole in the shaft with the hole in the clutch dog, install the pin and then, new clutch dog retaining springPosition three coils over each end of the pin, making sure none of the coils overlap or are loose
16Locate the propeller shaft assembly and align the forward bearing housing with the detent lever toward the topPush the detent lever down, into REVERSE positionBe sure the thrust bearing and the thrust washer are properly positionedInsert the propeller shaft assembly into the gearcase, being sure to align the shift housing pin with hole in forward end of gearcase housing