1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 186Get this manual
rn 3Place the -ring Q) in groove in the impeller housing4Lightly coat the exterior of the impeller cup with OMC Gasket Sealing CompoundInstall the cup in the impeller housing ITJ 5Install the water tube grommet with the inside taper
facing up[] 6Install the impeller housing cover
[] 7Apply OMC Adhesive sealant to flat side of the impeller housing grommet Install the grommet, flat side down[] 8Lightly coat the liner with oilWith counterclockwise rotation, install the impeller into the liner with slot for impeller cam facing out[] 9Run thin bead of OMC Adhesive sealant in the seal groove, and install the special shaped a-ring seal
Installation
1Apply OMC Gasket Sealing Compound to both sides of new impeller plate gasket CDInstall the gasket and impeller plate 2Apply OMC Triple-Guard grease to new impeller a-ring Slide the a-ring down the driveshaft until it contacts the impeller plate