1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 185Get this manual
Propeller InstallationV4 &
1Avoid accidental starting of engine while changing propellers; twist and remove all spark plug leads
2Place eng ine's shift lever in NEUTRAL3Coat the propeller shaft splines sparingly with OMC Triple Guard grease
OJ 4Place the thrust bushing in the propeller, then slide the
assemb ly onto the propeller shaft
OJ 5Install the thrust washer on the propeller shaft splinesOJ 6Install the propeller nut and tighten to torque of 120
inIbs(14 Nm)If cotter pin holes in the propeller nut and propeller shaft are not aligned, continue to tighten the nut until hey are in lineDo not loosen
OJ 7Insert new cotter pin through the propeller nut and
sh aftBend its ends over the nut to secure the assembly8Make sure engine is in NEUTRAL; give propeller spinIt must urn freely
Water Pump ServicingAll Models
If the gearcase has been in service for any length of time, it is good policy to install water pump repair ki tTo install the repair kit, proceed as follows: Removal