1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 127Get this manual
STEPCHARGE COIL TEST, V4 MODELS Ground Test 1Disconnect the starboard side Packard connector between stator and power pack2Attach test adapter from Kit, PIN 437270, to stator connector3Set peak-reading voltmeter to "POS" and "500"
rn 4Connect the meter black leadleads.a Crank engine and observe meter atconnectconnection: lead to clean groundAlternately meter red between brown, brownwhite stator engine each
Any reading indicates charge coil is grounded Locate and repair ground, or replace stator assembly5If no reading is indicated in Step 4, go to Output TestOutput Test 1Set peak-reading voltmeter to "POS" and" 500"
m 2Attach meter black lead to brown stator leadAttach meter red lead to the brownwhite stator lead3Crank engine and observe meter: If meter shows 250 volts or higher, go to next step indicated in Troubleshooting Sequence Chart, Page 3-24 If meter shows less than 250 volts, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test INotel All ohmmeter tests must be performed with engine NOT running