1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 85Get this manual
1331 9Clip float valve to floatInstall float assemblyTighten hinge pin retaining screw securelyInstall float bowl gasket134110Adjust float height with carburetor body invertedFloat must be level with gasket surface in (0,8 mm)If adjustment is required, do not put pressure on float valve and seat11Adjust the float drop with carburetor body in normal positionThe drop dimension to bottom of float should be between 1116-1 in(17-28 mm)12Install high speed fuel orifice with OMC Driver, PI 317002, and install float chamber plugTorque plug to 30-35 inIbs(3-4 Nm)135113Install float bowl and retaining screwsBack out screws in their holes to engage original threadsTorque screws in sequence to 18-24 inIbs(2-3 Nm)1361 14Install new O-ring seal and attach main body to throttle bodyTorque mounting screws to 45-55 inIbs(5-6 Nm)INotel When positioning carburetor main body to throttle body, be careful not to rollO-ring seal out of position