1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 65Get this manual
INote Push
fuel hose off fuel fittingsdon't pullIf pushing won't separate hose and fitting, carefully cut the hose along its side and peel it back to avoid damaging the fittings
3Carefully, remove the oil supply hose from the pump's oil inlet fitting
[]] 4Install and secure 10-in(25 cm) length of 114 in(6,35 mm) 1.0clear vinyl hoseA few inches from the loose end, measure carefully, and mark the hose every'h in(12,7 mm) for inches (101,6 mm)
5Fill the hose with Evinrude or Johnson Outboard Lubricant, and run the eng ine to eliminate air from the base ofthe hoseShut off the engine, and add or eliminate oil until its level is even with the highest mark6Start the engine, and monitor the pump cycles by using fuel pressure gauge or by putting light finger pressure on the outlet hoseThroughout the RPM range, the oil level in your hose should drop inches (76 mm) between to pulses7If your results vary, check the pulse limiter fitting before replacing the pump