1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 119Get this manual
Ignition Component ReplacementCD IIAmp
'" 1To avoid accidental starting of engine while servicing, twist and remove all spark plug leads
1sl 2Remove the screws retaining the ignition component that is being replacedrJl 3UFI- If the charge coil or ignition module is being replaced, separate the bullet connectors underneath the ignition module
[!] 4Remove the wire clamp from the ignition plate
rv from the powerheadplate screwsLift the ignition plate 5Loosen the five ignition
[!] 6Remove the plate from bottom of the ignition plate7Remove the leads from the spiral wrap and from the ignition component8Apply OMC Ultra Lock to the threads of the component retaining screwsLoosely install the new ignition component on the ignition plateConnect bullet connectors if necessaryf811gl 9Route leads and install clamp