1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 99Get this manual
Assembly 1Place leaf valves on leaf plateIf new valves do not seat on the leaf plate, turn the leaf valves over r::=J Used leaf valves must not be turned over for reuseLeaf
valve may break when returned to service, causing serious powerhead damage2If any leaf valves are standing open, apply light pressure using pencil eraserIf leaf valve closes with light pressure, valve is acceptableIf not, inspect leaf plate for high spots or burrsDo not lap leaf platesIf plate is too smooth, the leaf valves may stick closed after off-season storage3Apply OMC Locquic Primer to mounting screws and allow to air dryf51 4Apply OMC Screw Lock to mounting screwsWipe off excess adhesive5Assemble leaf valve shim (if required) and leaf stopInstall two screws near center of leaf stopDo not tighten1254
161 6Hold leaf valve assembly in horizontal positionThis will
usually align leaf valves over ports in leaf plateTighten the two screws evenly