1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 45Get this manual
Throttle Control Rod 1With the engine not running, ensure that the idle speed screw is firmly against its stop and both carburetor throttle plates are closed[]] 2Rotate the socket on the throttle control rod to obtain 0.020 in(0,5 mm) gap between the throttle cam and cam follower 3Install the throttle control rod socket on throttle cam and verify
gapWide Open Throttle Stop
[]] 1Advance the throttle lever to wide open positionW
2The carburetor throttle shaft pins must be exactly vertical at wide open throttle
[]] 3Loosen the locknut and adjust the W.O.Tstop screw to adjust pin orientation to exactly vertical4Tighten the locknut and recheck pin orientation at wide open throttle
Throttle Cable Installation Tiller Models
1Turn idle speed adjustment knob fully counterclockwise to minimum slow speed position
2Attach throttle cable to throttle lever upper hole using pin and cotter clipCotter clip must be installed parallel to raised rib on lever