1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 163Get this manual
10Coat the shift rod a-ring with OMC Triple-Guard grease and install in shift rod bushing rn 11Place new washer and bushingGasketOMC ShiftCom on Rod Bushing Installer, PIN 304515Apply OMC Sealing
pound to the outside diameter of the shift rod bushingUsing mallet, drive the bushing into the gearcase12Oil and place the forward bearing cone and roller assembly in the forward bearing cup
13To install the forward gear and the shifter lever and yoke assembly, begin by threading OMC Yoke Locator, PIN 319991, through the shift rod bushing and into the shifter yokeRemove the cradle from the yokeThen, while pulling on the yoke locator, guide the assembly into the gearcaseThe forward gear should come to rest against the forward bearing, and the shift lever should be located in the slot at the bottom of the gearcase