1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 161Get this manual
Assembly
INote Make no dry assemblies
Lubricate bearings, shafts, and gear with OMC Ultra-HPF gearcase lube
1Oil the small bearing and install it in the propeller shaft bearing housing using OMC Bearing Installer, PIN 339751Press against the lettered side of the bearing when installing
rn 2Oil the large bearingBearing Installer, the propeller Press and install it in shaft bearing housing using OMC PIN 339751
against the lettered side of the bearing when installing32560
3Install two new seals back to back using OMC Seal Installer, PIN 335822Install the inner seal onto the tool with lip facing away from the toolInstall the outer seal onto the tool with lip facing the toolApply OMC Gasket Sealing Compound to the metal casing of the sealsInstall the seals into the housing until the tool is seatedApply OMC Triple-Guard grease to the seal lips after installing4Apply OMC Triple-Guard grease to new bearing housing a-ringPlace the a-ring in the bearing housing groove