1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 330Get this manual
wrench installed 90 to the special tool, tighten the end cap to torque of 18-21 ftIbs(24-28 Nm)Tighten band nut securelyDo not lay the tilt cylinder on its side because oil will leak out of the band nutPlace the two nylon bushings back in the large hole at the base of the tilt cylinderPosition the tilt cylinder in the manifoldInstall both upper and lower hydraulic lines finger tightBe sure there is an O-ring on each end of the hydraulic linesTighten the fittings on the ends of the hydraulic lines to torque of 14-18 ftIbs(19-24 Nm) 252627Thread the end cap into the cylinderUsing torque
27 28Position the manifold as shownInstall the tilt cylinder pin281 29Rotate the unit into its normal operating positionUsing