1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 328Get this manual
11Oil and install the manual release valve Thread lll the valve all the way into the manifoldTighten the
valve to torque of 45-55 inIbs(5-6 Nm)Using OMC Retaining Ring Pliers, PIN 303857, install the retaining ring with the sharp edge of the ring facing out
1121 12Oil and install the trim-up relief valve seat and O-ringPlace the core and spring in the seatr:J3l 13Place the steel ball in the manifoldOil and install new filter valve seat and O-ring in the position shown
141 14Insert the filter up through the manifold plate Using
the three screws, flat washers, and lock washers, secure the
manifold plate to the manifoldTighten the three screws evenly
so the plate does not become cockedTighten the screws to torque of 25-30 inIbs(2,8-3,4 Nm)15Clean the oil reservoirInstall new O-ring on the reservoirf.i5l 16Position the oil reservoir on the manifoldInstall the three retaining screws with lock washersTighten the three screws securelyr:j6l 17Oil the components of the expansion relief valveUsing your thumb, press the valve seat CD and O-ring into the manifoldThen, press the valve core Q) and O-rings into the seatInsert the spring into the valve corerr7l 18Insert the trim-down pump relief valve and spring into the manifold in the position shownrr7l 19and install new high pressure port O-ring in the position shown