1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 326Get this manual
73 12935
73 52Remove and discard the seals from the trim pistons
Carefully clean the trim pistons and rods and install new sealstrim sleeves from the manifoldWhen removing, rock the sleeve back and forth with your fingers while prying with the toolscoringReplace the sleeves if scuffed or groovedC0A2488
74 53Using OMC Trim Sleeve Remover, PIN 325065, pry the
751 54Inspect the cylinder bore of each of the sleeves for 76 55Remove the seals from both trim sleevesClean the
sleevesOil and install new seals on the sleeves, as shown
56Remove the manifold from the holding fixture and clean the
manifold thoroughly in fresh solventBlow excess solvent from the internal passages with compressed airIt is essential that the manifold and all components be kept absolutely clean and dust freeAny dirt in the system could cause scoring of cylinder bores, sticking of valves, or damage to pump componentsAssembly Use only OMC Power TrimlTilt and Power Steering Fluid or GM Dexron I automatic transmission fluid to fill the hydraulic system