1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 317Get this manual
o C0A2417
f511Be sure the manual release valve is screwed in all the wayRemove the retaining ring using OMC Retaining Ring Pliers, PIN 303857Remove the manual release valvef61 2Inspect the a-ring in the manual release valve for nicks and EJ cutsInspect the rubber tip of the valve for tears or deformation
[2] 3Remove the oil level plug from the oil reservoirInspect the a-ring on the reservoir plugReplace the a-ring, EJ lf necessary
Remove the two rigid steel lines connecting the top and bottom of the tilt cylinder to the manifoldWhen removing the line from the top of the tilt cylinder, you will have to hold the tilt cylinder band nut with one wrench while removing the line connector with another
r,Ql 6Both hydraulic lines have a-rings at each endInspect all four -rings and replace -rings if necessarypin out of the unitRemove the tilt cylinderVery carefully and slowly, cycle the cylinder once or twice while aiming the oil feed ports down toward the oil drain panRemove the two nylon bushings from the cylinderf12l 8Currently, there, are two styles of tilt cylindersIdentify which one you have prior to making any repairs or selecting replacement partsThe cylinder shown at the top of the figure is referred to as the Showa brand cylinderThe cylinder shown at the bottom of the figure is referred to as the Presto lite brand cylinderWhen replacing an entire cylinder, either one can be usedWhen replacing individual parts including the band and band nut, only those specified in the parts catalog for that particular brand must be used56C1eng