1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 297Get this manual
fJl 7Attach reservoir to cylinder body with three PozidrivscrewsTorque the screws to 35-52 inIbs(4-6 Nm)1sl 8With cylinder body in vise, lubricate trim pistons and push piston assemblies fully into bodyFill cylinders with OMC Power Trim!Tilt and Power Steering Fluid
19l 9Screw trim cylinder end caps into cylinder bodyUse OMC
Trim Cylinder End Cap Removerllnstaller, PIN 436710, or OMC Universal Spanner Wrench, PIN 912084, to torque caps to 60-70 ftIbs(81-95 Nm)f1Ol 10Lubricate tilt cylinder piston and push assembly fully into cylinderFill cylinder with fluidf11l 11Screw tilt cylinder end cap into cylinder bodyUse OMC Tilt Cylinder End Cap Removerllnstaller, PIN 326485, or OMC Universal Spanner Wrench, PIN 912084, to torque cap to 58-87 ftIbs(79-118 Nm)r:J2l 12Fill reservoir with fluidPut on cap and cycle unit several times(Only tilt cylinder will retract Check fluid level with cylinders extendedRetract tilt cylinder13Check bushings in cylinder body and replace, if worn