1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 281Get this manual
7(continued) If no voltage at V3, disconnect bluewhite tilt limit switch bullet and t? by-pass tilt limit switchRepeat Step 7If you now have voltage at V3, adjust or replace tilt limit switch If voltage at V3, go to Step 88Reinstall UP relayPush blades only halfway into UP (blue) end of bracket [!] [3] 9Push UP trim button and check for voltage at V4 on relay blade (M terminal of relay) If no voltage at V4, go to Relay Ohmmeter Test If voltage at V4, go to Step 1010Disconnect trim motor's blue and green power wire connector (leave relay in bracket)11Push UP trim buttonCheck for voltage on blue wire If no voltage on blue wire, check blue wire from relay bracket to motor connector If voltage on blue wire, check motor and leadDOWN CIRCUIT 12Mark UP and DOWN relays, and remove relays from relay bracket
[!] 13Connect voltmeter red lead to V5 and black lead to V6 If no voltage at V5, check red wire between starter solenoid terminal and relay bracketIf red wire is OK, check black wire between relay bracket and engine ground If voltage at V5, go to Step 14f1l 14Connect voltmeter black lead to clean engine ground, and voltmeter red lead to V7 (greenwhite)