1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 255Get this manual
Stator Resistance CheckAll Models INot
Disconnect battery cables before proceeding with this check
Gl 1Disconnect stator yellow and yellowgray leads from terminal board
Calibrate ohmmeter on appropriate scaleConnect one ohmmeter lead to stator yellow lead and the other ohmmeter lead to stator yellowgray lead Refer to chart below for the correct value for your engine and stator combination Repair or replace stator if reading is not correctDR4132
f41 3To check for grounded condition,
disconnect both ohmmeter leadsCalibrate ohmmeter on appropriate scaleConnect one ohmmeter lead to clean engine ground and the other ohmmeter lead alternately to both stator leads Ohmmeter should show high reading If ohmmeter shows low read ingstator is grounded and should be repaired or replacedAfter replacing the stator and charge coil assembly, verify correct maximum spark advance using the procedure outIi ned in Section 1DR4133