1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 156Get this manual
Assembly
r:-:=J Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
INotel Use new gaskets, seals, and a-rings during assemblyf11 1Apply OMC Needle Bearing Grease to the 28 wrist pin bearingsInstall the bearings in the wrist pin boreAlign the bearing in the bore using OMC Wrist Pin Bearing Tool, PIN 336660f211al 2Place the two wrist pin thrust washers on the tool with flat side of the washers facing outf41 3The connecting rod has no specific orientationSupport the piston in OMC Piston Cradle, PIN 326573Oil the wrist pin bore and wrist pinf41 4Install the wrist pin through the piston and connecting rod, pushing the tool out through the pistonDR1641