1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 153Get this manual
Cleaning Before inspecting or assembling powerhead, all internal components must be perfectly clean and free of contaminants1Remove any carbon accumulation from exhaust port areas2Remove any carbon accumulation from cylinder head combustion chambers3If cylinder walls are glazed from extended use, use medium grit cylinder hone to resurface wallsUse slow RPM to achieve strong "crosshatch" pattern for best oil retention and ring sealingTo avoid piston or cylinder block damage, restore the chamfer to all port edges using ball hone or other suitable tool'" To avoid personal injury, wear eye protection and rubber OMC Gel Seal and Gasket Remover i gloves when using
r:;l 4Use OMC Gel Seal and Gasket Removerto remove all traces of gaskets, adhesives, and OMC Gel-Seal" from the cylinder block and crankcase