1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 133Get this manual
Sensor Coil Ohmmeter Test Notel All ohmmeter tests must be performed with engine not
running
1Before proceeding, you must verify that the ohmmeter red lead is the" +" leadCalibrate meter on appropriate scaleAttach to known good diode as shown Meter must show low reading When meter leads are reversed, meter must show high readingDR4064
2If your test results are opposite, reverse the internal meter lead connections so the red lead represents "+"
3Attach ohmmeter red lead to terminal "E"
4Alternately, attach ohmmeter black lead to terminals "A", "B", and "C"Meter reading at each connection should be:
Stevens AT-101 meter300 50 ohms Merc-O- Tronic M-700 meter800 50 ohms Fluke 29 Series II meter900 50 ohms
INote The Fluke 29 Series II meter must be set to the low ohms