1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 129Get this manual
Ohmmeter TestStop Button
INotel All
tests must be performed with the engine not contain combination stop button
running
1sl 1Most steering emergency stop device
When the clip and lanyard assembly is removed, the emergency stop device is in the STOP position When the clip and lanyard assembly is installed, the emergency stop device is in the RUN position To stop the engine when the clip and lanyard assembly is in place, press the stop button inward until the engine stops2Install the clip and lanyard3Separate the 5-pin Amphenol connector between the power pack and stator assemblyf61 4Calibrate an ohmmeter on appropriate scaleConnect meter leads between the stator 5-pin Amphenol connector, terminal "E"and clean engine ground The meter must show high reading5Momentarily press inward on the stop button The meter must show low reading6Remove the clip and lanyard The meter must show low reading Q)