1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 68Get this manual
6Test the "no oil" warning circuit Connect shop tank with 50: fueloil mix to the fuel inlet fitting Remove the protective cap from the oil inlet fitting Start the engine and run at 1000 RPM in gear After the residual oil is exhausted from the oil line, the "no oil" circuit should activate the warning horn The signal should be an urgent 112 second on, off12
INote The
"Iow oil" and "no oil" circuits alert the operator to possible problems with the VROft systemYou must be sure they are functional before continuingIf they are not functional, serious powerhead damage might occur
7Complete the installation by connecting the oil supply hose to the engine's oil inlet fitting
Before attaching hose, squeeze oil primer bulb to purge all air from oil lineAllow small amount of oil to flow from the hose to remove any contaminants that might be in the line Install the oil hose on the oil inlet fittingUse only the ratchet clamp supplied with the kit to secure the lineTighten with pliers To complete priming, squeeze oil primer bulb until oil is visible at the sight tube located in the oil hose near the pump During break-in period, the engine's fuel tank must have operation 50: fueloil mixture in addition to