1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 40Get this manual
Synchronization and Linkage Adjustments 50, 60, 65WM, 70 Remote Control NoteIt is important that this step-by-step procedure be followed
in sequence and be performed exactly as written to ensure consistent engine idling and smooth operation throughout the RPM rangeINotel The flywheel has two timing gridsFor remote control
models, use the second timing grid (flywheel rotating in clockwise direction)I Note Remove the throttle cable from the throttle control arm
and the anchor pocket beginning this procedureSet Timing Pointer
INote If the timing pointer or intake manifold has been disturbed,
check the top dead center timing pointer alignment&
1To prevent accidental starting of the engine while servicing, twist and remove all spark plug leads
2Center the timer pointer Rotate the flywheel in clockwise direction until the cast-in mark is approximately 1V2 in(4 cm) past the timing pointer(
rn andInstall in center portion PIN 384887, in No.1No.1 piston3OMC Piston Stop, spark plug hole turn until it contacts the