1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 249Get this manual
Assembly]1If the reverse gate was removed during disassembly, install reverse gatebushings ,and shafts to jet housingPosition shafts so holes align with holes where retaining screws make contact2Tighten screws to 60-84 inIbs(7-9 Nm)After installation, check to make sure the reverse gate moves freely rn 3Place any other position.position shownThe roller will not roller into cam in assemble in
[] 4Place cam roller on reverse gate stud, and tighten nut to 60-84 inIbs(7-9 Nm)
5Install bushing
, eccentric nut ,
and cam screw