1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 231Get this manual
31 12911301
a;J=OR=20""'"62-J
7Oil, then install new bearings in the bearing housing using OMC Bearing Installer, PIN 326562 Press against the lettered side of the bearing to prevent damage to the bearings when installing
Use OMCSeallnstaller, PIN 326551, to install two new seals back to back in the rear of the bearing housingApply OMC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with lip facing toward the bearing housing, then the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing9lightly apply OMC Triple-Guard grease to new bearing housing a-ringInstall the a-ring in its groove in the housingInstall new a-rings on the retaining screws
Driveshaft Bearing Housing Service
INote If the needle bearing in the housing
is worn, the bearing and housing must be replaced as an assembly1Remove the two driveshaft bearing housing seals using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Discard the seals2Remove the a-ring from the bearing housing and discard