1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 227Get this manual
9Remove the pinion and driveshaft from the gearcase as followsPull up on the shift rod to engage FORWARD gear position [H]
Using OMC Driveshaft Holding Socket, PI 334995, and an 11,1,6 inopen-end wrench, back the pinion nut off the driveshaftPad the handle of the wrench to prevent damage to the gearcaseThe driveshaft to pinion taper is locking taperIf necessary, use OMC Puller, PI 387206 CD, and OMC Backing Plate, PIN 325867 Q), to break the lockInstall the tools, as shown, by clamping them around the driveshaft with the tool's set screw aligned with the impeller drive cam slotTighten the set screw into the slotAlternately tighten the two vertical screws against the backing plate inserted between the puller and the gearcase until the driveshaft pops loose from the pinioningshim(s) (1), thrust and thrust bearing from the gearcaseReach inside the gearcase and remove the pinionIt may be necessary to pull up on the shift rod to gain enough clearance to remove the pinion