1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 196Get this manual
5Assemble the port and the starboard stern brackets onto the swivel bracketInstall the tilt shaft bolt through the following components: Tang washer, bushing, port stern bracket, thrust washer, swivel bracket, thrust washer, starboard stern bracket, bushing, washer
1251 Position the tang on the port washer Q) toward rear of the
stern bracketInstall the nut loosely on the tilt shaft bolt
stern bracket flange into the port stern bracket flangeTighten the screws to torque of 144-168 inIbs(14-16 Nm)Tighten the nut on the tilt shaft bolt to torque of 14-16 ftIbs(19-22 Nm)
ill screws Install the two screws through the starboard
6Apply OMC Nut Lock to threads of the two flange
7Install the thrust rod in the stern brackets