1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 163Get this manual
1491 53Install starboard lower engine cover mount bracket and torque screws to 60-84 in Ibs(7-9 Nm)
54Install the complete ignition, electrical, and fuel systems
ill and ignition wiring is routed and clamped in its original
positionInstallation
To prevent possible fire or explosion, make sure all electrical
1Position new powerhead gasketDo not use sealer on the gasketr:;l 2Coat driveshaft splines with OMC Moly LubeDo not coat LJ top surface of driveshaft as lubricant here may prevent seating of driveshaft in crankshaft3Lower the powerhead assembly into placer:;] 4Apply OMC Gasket Sealing Compound to threads of the
l3J eight
powerhead retaining screwsInstall and torque the screws to 18-20 ftIbs(25-27 Nm)