1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 134Get this manual
3Crank engine and observe meter reading: Rope or Amp 1.50 Volts 12 Amp 0.5 Volt
PCE0068
If meter shows higher voltage, go to STEPPOWER PACK TEST If meter shows lower voltage, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test
INotel All ohmmeter tests must be performed with the engine NOT running1Calibrate ohmmeter on appropriate scale2Insert jumper wires in sensor coil terminals listed in chart
Rope or Amp liB", IIC"