1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 121Get this manual
Stator ServicingCD II12 Amp Removal
i and remove all spark plug leads
'" To avoid accidental starting of engine while servicing, twist
1Remove the flywheelRefer to Flywheel Servicing, Page 3-82Disconnect stator yellow and yellowgray leads at terminal board3Separate the stator 5-pin Amphenol connectorRemove the blackyellow stop circuit lead from terminal "E"
[II 4Remove stator retaining screws Installation f21 1Remove any varnish around retaining screw holes on both sides of statorThe stator must have metal to metal contact with the crankcase head and its retaining screws2Position the stator on adapter and route the leads3Apply OMC Nut Lock to mounting screwsInstall screws and torque them to 120-144 inIbs(14-16 Nm)4Attach stator yellow and yellowgray leads to terminal boardCoat final connection with OMC Black Neoprene Dip5Install blackyellow stop circuit lead in 5-pin Amphenol connector, terminaIIE" 6Install the flywheelRefer to Flywheel ServicingPage 3-8