1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 90Get this manual
Warning Signals r:::-=J Push fuel hose off fuel fittingsdon't pullIf pushing won 't
separate hose and fitting, carefully cut the hose along its sjde and peel it back to avoid damaging the fittings"Low Oil" Signal complete procedure for testing the "low oilcircuit can be found in Installation Recommendations, th is section"No Oil" Signal 1Connect shop tank with 50: fueloil mixture to the fuel inlet fitting2Carefully, cut the oil supply hose from the pump oil inlet fitting3Start the engine and run it at 1000 RPM, in gear4After the residual oil is exhausted from the pump, the "no oil" circuit should activate the warning horn The horn should sound
second on,